Jump to content

Skeeed3r

Members
  • Posts

    20
  • Joined

  • Last visited

Everything posted by Skeeed3r

  1. Skeeed3r

    Link keypad on G4+

    Thanks for the manuel and the Config But to purchase i musst Choose an Protocol -->
  2. Skeeed3r

    Link keypad on G4+

    Ok, but how do I get the Motorsport firmware to run with the link? and which Protocoll i need ? CanOpen or J1939 thanks for your Support
  3. Skeeed3r

    Link keypad on G4+

    @Adamw any change i can order one?
  4. Skeeed3r

    Link keypad on G4+

    I am also interessted in
  5. Skeeed3r

    Link keypad on G4+

    Very nice, can you share your Config ?
  6. Skeeed3r

    LINK CAN KEYPADS

    Hi, will they work with the G4+ ? If not ... voting started
  7. and can you test it without PDM?
  8. i used this one http://www.turbofast.com.au/TFelectronics/PageFiles/CAN_EGT_Amp.html never get any Problems with these.
  9. @Samuarai Supra if iam right do you use the Toucan Display Keypad function without a PDM ?
  10. Skeeed3r

    CAN Keypad

    Fueltech release a new Keypad: https://www.fueltech.net/collections/switchpanel/products/switchpanel-8 @Adamw What do you think, could be worked with the LINK ecu ?
  11. Hi everyone, did anyone know if the new Can Lamdba from ECU Master working with the Link G4+ ? http://www.ecumaster.nl/en/accessories/lambda-to-can.html Thanks
  12. Skeeed3r

    CAN Keypad

    Did any Keypad know work with the Link Ecu ?
  13. Hello everybody did anybody run a Traction Control Setup with Dirve by Wire ? Idea is to make a Traction Control over the throttle body (traction lost reduce the opening level from the throttle), this should be possible with a table %Slip and throttle target. Know my problem is to do this for every gear separately. Anyone have a idea ? Thanks Regards
  14. Skeeed3r

    G4+ Thunder OBD-II

    Which Can odb2 adapter to you use ??
  15. Skeeed3r

    LC2 Cal table

    Hi everyone, do I need for an Innovate LC2 a special cal table or can I use the LC1 one ? And where can I find this cal if I need one thanks a lot
  16. Hello, i want to connect two Temperature sensor (Oil Temp and Fuel Temp) to the Link G4, which Sensor types are supported ? Can I used some standard senor ? or which one are supported ?  thanksÂ
  17. Hello everyone, i am looking for the correct wiring for the Boost solenoid form Link with a External Wastegate. Thanks for your Help. Â
×
×
  • Create New...