Jump to content

Aktar Hussain

Members
 View Profile  See their activity

  • Posts

    4

  • Joined

  • Last visited

    Never

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Aktar Hussain's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Aktar Hussain
    Aktar Hussain joined the community
  2. Aktar Hussain
    Hi, My car (R32 GTR) is running a Link G4 Xtreme ECU and I'm looking to replace the factory Knock sensor with Bosch sensors that will work with the ECU. Can anyone tell me the part no. for the Bosch knock sensor or make and model of cars that are fitted with the sensor so that I can order the parts from a dealer? One more queetion, do I need to change any of the settings to my map if I load the latest version of the PC link software/firmware (ver 4.6.0.601)? Think I read something about the limit settings being different to how they were previously? Thanks Aki
  3. Aktar Hussain
    Hi, I know this is probably a long shot but does anyone on here have a Skyline GTR RB26dett G4 map that I could use as a base map for my car? I have G4 xtreme ECU that I’m plan on fitting to my car over weekend and was hoping that I someone would be kind enough to let me copy their map so that I could use it as a starting point before I begin? Please let me know if you can help? Thanks Aktar
  4. Aktar Hussain
    OK, I've updated the table (see attachment) and there are only 2 pins from the original ECU that I can’t seem to find a home for in the G4 Xtreme ECU, Pin 45 and 16. As I understand (with the factory ECU) when key is tuned to ignition live it sends a signal to the ECU via pin 45. The ECU then provides a ground to pin 16, this activates the ECCS relay which then provides power to pins 49 and 59. How do I replicate this response with the G4 ECU or do I just use pin 45 as +14v input for and connect pin 16 to sensor ground on the G4?
  5. Aktar Hussain
    Hi All, I need a little help fitting a G4 extreme ECU to my Skyline R32 GTR. I already have a header board and I’m trying to create my own adaptor loom so that I can connect directly into the factory connector plug. I have attached a table showing how I think the wires between the G$ Xtrem and the factory plug should be connected, could someone confirm if the wiring is correct? My main concern is the relating to the ECCS relay (which is pin 16 on the factory connector plug), I’m not sure as to which pin I should connect this to on the G4 Xtreme connector plug? Hope someone can help? Thanks Aki
×
×
  • Create New...