Win
Members-
Posts
11 -
Joined
-
Last visited
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
Win's Achievements
-
Hi. I just installed a S15 ecu into a s13 sr20det. Firmware is up to date. With the default map I can’t get spark. When I put test mode on, the outputs just stay low. The edge is set to falling. Strange thing is if I change my ignition to distributor then ignition 1 will have an output in test mode. If I change trigger edge to rising then I get outputs on all 4 outputs. but if I plug this into my igniter it would fry it. Is there something I should do here?
-
Have anyone sent a close loop correction % output to a dash2 pro before? using the test calculator it tells me to use a 16 bit long code. I played around with the multiplier, divider and offset but the dash just wont read correctly.
-
you can buy one of these switches from us for your flat foot shifting. As for launch control you don't need a clutch switch to activate it. https://autodream.ca/product/flat-foot-shifting-switch/
-
Win joined the community
-
I can't find this firmware any where on the site, can you add a link to it here with some instructions. I upgraded my extreme to G4+ extreme now my dash is not working also.
-
we need to have a 6 injector driver ECU, because the Atom and the stom can't run 6 injectors using 3 outputs. who is with me on this?
-
have you verify that you have 12v at the injectors, and there is fuel pressure at the rail?
-
it for wasted spark setup, sequential injection, single turbo.
-
This is only a base map to get the engine running on stock injectors and MAP. After I get it all configured I will upload it again if you need it
-
We are working on one using a silver Extreme. we can post the base map once we have it up and running. Are you using an external E-throttle controller?
-
Try this one, you will need to change the fuel master# from 800cc to what ever size you are using