Win

Hi. I just installed a S15 ecu into a s13 sr20det. Firmware is up to date. With the default map I can’t get spark. When I put test mode on, the outputs just stay low. The edge is set to falling. Strange thing is if I change my ignition to distributor then ignition 1 will have an output in test mode. If I change trigger edge to rising then I get outputs on all 4 outputs. but if I plug this into my igniter it would fry it. Is there something I should do here?

Have anyone sent a close loop correction % output to a dash2 pro before? using the test calculator it tells me to use a 16 bit long code. I played around with the multiplier, divider and offset but the dash just wont read correctly.

you can buy one of these switches from us for your flat foot shifting. As for launch control you don't need a clutch switch to activate it. https://autodream.ca/product/flat-foot-shifting-switch/

I can't find this firmware any where on the site, can you add a link to it here with some instructions. I upgraded my extreme to G4+ extreme now my dash is not working also.

we need to have a 6 injector driver ECU, because the Atom and the stom can't run 6 injectors using 3 outputs. who is with me on this?

have you verify that you have 12v at the injectors, and there is fuel pressure at the rail?

it for wasted spark setup, sequential injection, single turbo.

This is only a base map to get the engine running on stock injectors and MAP. After I get it all configured I will upload it again if you need it

We are working on one using a silver Extreme. we can post the base map once we have it up and running. Are you using an external E-throttle controller?

Try this one, you will need to change the fuel master# from 800cc to what ever size you are using