Jump to content

Brody Walker

  • Content Count

  • Joined

  • Last visited

About Brody Walker

  • Rank

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Ok that worked. I then got error 4, swapped the motor + & - around & calibration was successful! Thanks so much for your help.
  2. Here you go. Let me know if you need anymore information. TP Calibration map.pclr TP Calibration.llg
  3. Great thank you. I have mounted it & now a little stuck. I'm getting error 5: TPS (main) Movement zero when trying to calibrate the TPS. I have calibrated APS & can see movement on the E-throttle 1 Target table when I move the pedal. I can also see movement in TP main % when I move the throttle plate by hand. Throttle is set to keep running when stalled & PID settings are as per help guide. Have a missed something with my wiring or setup? Wiring as per below: I have the external module wired up as per below: Aux 4 - Signal 1 Aux 8 - Signal 2
  4. Great thanks for the reply. I have purchased the module due to time constraint. Can the module be mounted in the engine bay or does it need to be mounted in the cabin? Cheers Brody
  5. I'm switching to ethrottle on my R34 GTT with a G4+ plugin. Ive read through all the wiring diagrams ect. The ethrottle auxiliary output setup states to use aux4 for signal 1 & aux9 for signal 2. I've had a look at the pinout & there is no Aux9. Can I use aux8 which is assigned to my CEL instead or ignition 7/8 aux out on the expansion loom? If not what do I need to do? Thanks for the help.
  6. Hi there, I've been running a link knock light for about 3 years now & it use to work great. It would turn green the moment the engine started. For the last few months it no longer turns green when I initially start the engine, it takes a engine load/revs to register the engine has started. It's gradually been getting worse & now doesn't register unless it's at full load or at 6000+ rpm. I bought another sensor but it still does the same thing. Is there anyway to reset the unit? Thanks for the help.
  7. Legend! that's worked, thank you so much.
  8. No luck, now I got this which just looks like a blank page.
  9. Hi there, I have somehow hidden the "config" & "tuning" pages as seen in the attached. All I can see is the "logging" screen. I have opened previous saved maps & connected the laptop to the ecu but it still only displays the "logging" screen. Is there a way to get it back without creating whole new pages?
  10. Hi guys & girls. I have fitted a G4 plug n play to my r34gtt skyline. Whilst calibration I noticed that when I turn the key off the dash lights & gauges remain on, the radio however turns off. The only way to turn it off is to disconnect the battery. Power is still going to the ecu too.   have a auto watch security system installed if that's any help. Has  anyone ever had this issue before or know what it could be? Â
  • Create New...