Glenn
Members-
Posts
18 -
Joined
-
Last visited
Never
Glenn's Achievements
Newbie (1/14)
0
Reputation
-
Glenn joined the community
-
just curious as to whether or not going to the G3 lem would acutally be an improvement on an otherwise std f20c engine- any thoughts?
-
Does link have a recommended sensor to use for these two functions and where to purchase if not from Link electro?
-
duh! sorted- wasnt looking hard enough.
-
looked hard and for the life of me cant find the temp sensor unit on this thing- 85 tx3 b6t. any ideas?
-
Is the power supply for the blacktop sr20det CAS a simple switched 12v or do i need to supply it from the link?
-
Thanks a lot Cameron- for all the answers
-
Just looking through the G3 datalogging options and it looks like i am unable to log the speed input. Is this correct or am i missing something again
-
Am i able to configure the G3 LEM for a map signal output to interface it with the innovate datalogging system?
-
Does anyone know what the correct calibration settings are to allow the link G3 to show the correct AF's when using the innovate LM2 wideband
-
i have downloaded and followed the instrutions for the usb drivers- when the installation process is done it says the drivers cant be installed due to a fatal error- have tried this a few times all with the same result, is there anyhtinthim missing here or does anyone have any ideas?
-
Can someone tell me how to wire this in please- i have one but cant find a diagram of which wire does what