Jump to content

Guy Gove

Members
  • Posts

    6
  • Joined

  • Last visited

    Never

Guy Gove's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Hi there, I sent the following email and info to the [email protected] email address a week ago but have had no acknowledgment that it was received, so I have decided to post my problem here as well, here goes. 'Hello I recently purchased a plug and play ecu for a nissan CA18DET, part number NS13G4. I have installed the ecu into the car and successfully tested the inputs and outputs. The engine has yet to be fitted though so it has not been setup or run by the ecu yet. I have just started to configure the ecu for my application and updated the firmware to the latest available on the website this last weekend. I intend to run a MAF sensor for load and have run across a problem with the latest version of the pc link software. When I try to change the Y-axis of the fuel or ignition tables to Mass Air Flow (g/s) it produces a single row with the label 'Not Defined' Changing the Y-axis to Mass Air Flow (g/cyl) does appear to work though. However I wish to have my tables spanned in g/s. I have also noticed, using the software offline, that this problem does not occur if you open an older pcl file, downloaded with the previous version of PCLink. Loading an older pcl file and sending to the ecu does still cause the problem to occur. I have attached to this email a few screenshots of the problem as well as the two pcl files I've used to show the problem. I'd appreciate it if you could look into this and see if it is just a problem/incorrect setting on my side, or if it is a problem with the software.'
  2. I changed the com port to com2, tried the update again and it worked first time. Thanks for the help.
  3. Great, thanks. I'll give it a try over the weekend.
  4. Hello, I've just installed my plug and play ecu into my 200sx CA18det over the last couple of weekends. The engine is still being put together so it hasn't run on the new ecu yet. Anyway, today I decided to download the new software and update the firmware on the ecu. I installed the new software without loading the latest usb drivers, seeing the warning on the website about them. The problem I am having is that when I try to update the firmware the window just sits at the 'searching for ecu...' point and goes no further. Both versions of the PCLink software have no problem connecting to the ecu, but the firmware updater appears to not be able to find it. Please can you let me know what I could try in order to update the firmware. Thanks Guy
×
×
  • Create New...