Matt Petersen

Thanks Ashley. In the Link software it shows as ig3 being setup for tach. I am running the early Link ignitor that doesn't have a tach output on it so I have to drive it from the ecu. I will get an led test light and see if the Link is outputting a signal. The gauge cluster has a pot on the rev counter section which allows you to adjust it to match the required revs. Cheers Matt.

I have an LN130 Surf with a 1UZFE. The gauge cluster rev counter for the diesel is incompatible apparently so I got a 4cyl and a V6 efi gauge clusters. I have run the blue with white wire and cut the black tach wire from the gauge wiring but can't get either tach to work. I have the factory wiring diagram and it showed my which connector and wire was the tach feed. Everything else still appears to work. Obviously it has to be the wrong wire - anyone have Hilux/Surf experience on here? Cheers Matt.

If not are you aware of any ISC that can be used? Cheers Matt.

Thanks Ashley. Can the V5 G1 control it? Cheers Matt.

Thanks Ashley. I am running a V4 G1. Do you know if the O2 sensor on the 1UZ is also compatible? Cheers

Is it possible to use the factory 1UZ parts to improve the idle and cold start quality? If not is there an aftermarket ISC that can be used? Cheers Matt.

Thanks Simon. Would upgrading to the V5 code give me any benefits like Crank Decay? When the motor starts from cold it runs like it's running rich and you can smell the fuel, does this for about 20-30 seconds then it's fine. As the tuning takes a while as you need to let the cool right down again I was hoping someone would have a value I could get closer to. Cheers Matt.

I have a 1UZFE which runs very well, was dyno tuned and goes great. The only problem is the cold start configuration. Currently it's set to the following values :- Clamp 32 Cold Start 23 Crank Enrich 43 Volts Correction 15 It starts easily but runs rough for about 20-30 seconds after starting. As it's time consuming to alter these values and test due to the time taken for the motor to cool down again can anyone make any recommendations on these values? Using the online help it would seem that it's the Crank Enrich value that is wrong. The help says the base value is 70 and a smaller number means greater enrichment. It also says to refer to Crank Decay which isn't a visible setting on my screen. Cheers Matt.

Thanks again for your help Ashley, great service. Bought a Digitus adapter from www.ascent.co.nz the other day and it worked first time out of the box. Cheers Matt.

Thanks Ashley, excellent service. That's weird about the adaptor, I have been using it fine for a couple of years with no problems. Can you guys recommend a model or advise the one you used to test it? Cheers

Doh, double post, double basehead!.

Ashley, I was a basehead and didn't include my contact details with me LEM and USB cable and Serial Link that I sent you.... The serial cable is a Dick Smith unit, you can get the drivers from the website. [email protected] 04 3892180 Cheers Matt.

Ashley, I haven't included a contact sheet or anything when I shipped my ecu and cables to you. It has my return shipping info on the package but nothing else. It's the LEM with serial link and usb to serial cable. The cable is a Dick Smith adapter, drivers can be found on their website. Matt Petersen 04 3892180 Cheers

Thanks Ashley, sent it this morning so you should see it shortly. Cheers Matt.

Can I send the lot down to you guys to check out Ashley? If so what is the courier address? Cheers Matt.