Jump to content

Phillip Quinlan

Members
  • Posts

    10
  • Joined

  • Last visited

    Never

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Phillip Quinlan's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Awesome thanks Simon will let you know how I get on
  2. Oh bugger that's no good then so if I take the other 20teeth off the 24tooth wheel that should be able to get it to run with the dual post coils? And leave the single tooth rotor alone? what should I have priority set to with this setup?
  3. One other possibility the main board has the row of 4 dip switches what should these be set to? Could possibly hav something to do with ignition timing?
  4. Just noticed as soon as it tries to run the ignition advance goes right up to the limit which I hav set at 25
  5. Also I am not using air temp or oxy sensor could this be a issue?
  6. The cas has the 24 tooth wheel and a single on top of that, the main chip is d42v5e071205 and I have taken another picture of the smaller board on top for you should be attached , cheers
  7. Hi Simon still working on this same project believe it or not, i now have a version 5 but having issues once again its got spark but struggles to fire, it seems like the timing could be way out however i have set the base timing by changing the advanced limit to zero then setting it to 10degrees with the light. here is my pcl file attached and also some pictures of inside the link. any tips would be much appreciated, cheers
  8. Ohh really yeah well that would do it. Â Will look into an upgrade. Cheers simon
  9. Hi guys I have a lem v3 and have had it just wired up to my 4agze engine but running a turbo not the s/c. im using the standard cas and standard dual post coils for a waste spark setup with a link 2 channel ignitor. Â I have been tryning to get this to start up at the start i was running a subaru ignitor but it got hot while cranking over and lost one of its output channels. i hav since got a link ignitor but same thing is getting hot while cranking. its got spark so its trying to fire but with no luck of getting it to idle. the heating up issue was wondering if it could be a dwell setting?? if so am having trouble finding this on the hand controller? my ecu is a d42v3 was told it was running on a 4age turbo before i got it. will supply picture of internals attached for you. any help would be much appreciated. Cheers phil.
×
×
  • Create New...