shane lynch
Members-
Posts
6 -
Joined
-
Last visited
Never
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
shane lynch's Achievements
Newbie (1/14)
0
Reputation
-
shane lynch joined the community
-
Subaru G4 Storm RPM Limit Activation/Trigger Problem
shane lynch replied to shane lynch's topic in Link G4
Switching the 2 wires around at the cam sensor plug did fix the problem. -
Subaru G4 Storm RPM Limit Activation/Trigger Problem
shane lynch replied to shane lynch's topic in Link G4
There are some pic at 1200rpms with it fine and at 3200rpms with the problems. It is fine until arounf 3200RPMs and then it thinks it's hitting revlimiter 10000+ rpms. If I can force it to go past 4000RPMs, then it seems to go away. -
Subaru G4 Storm RPM Limit Activation/Trigger Problem
shane lynch replied to shane lynch's topic in Link G4
Video of RPM limit being activated Video of scope -
Subaru G4 Storm RPM Limit Activation/Trigger Problem
shane lynch replied to shane lynch's topic in Link G4
Any ideas? -
Subaru G4 Storm RPM Limit Activation/Trigger Problem
shane lynch replied to shane lynch's topic in Link G4
It has the wasted spark coil setup. Plugs are NGK BKR6E, which are resistor. Wires are some Carquest Global Solutions 7mm Suppression Cable. I have no idea on the specs of these wires. -
Link G4 Storm Car is a 2000 USDM Impreza 2.5RS, supposedly it has a built 2004 2.5l UDSM Sti short block. The heads, coils, etc are from the 2000 2.5RS. Car is turbo. Car starts and runs, but in the 3000-4000 RPM range it is getting some kind of bad signal. The RPM limit activation is kicking on because the Link G4 is seeing the RPMs randomly jump to 10000+ RPMs. I tried playing with the Trigger 1 and 2 filter settings and voltage settings, but haven't found anything that makes it better. I have been able to force the motor past 4000 RPMs a couple times and it seems to clean up. The trigger mode is set to Subaru V1-6.