Igor Polshchikov

Hi, I have an ej20G block with 1.6mm layered steel gaskets, 97wrx heads, TD05 16g (mitsubishi) turbo, FMIT, 3" turbo back exhaust. I am after a base tune map that would roughly fit the above. Any help will be greatly appreciated. Igor.Â

Sweet. That's what I thought. Is it absolutely necessary to have it seeing the tps? Its not reading it but seems to run and tune ok. Just sitting there on 10.

There was a sticker but it came off the first time I changed the ECU box. Definitely read "WRXROAD" and 90% sure it said 97. If its any help, there was another number on it reading 449.  The car is running ok, but if the chip is wrong what are my options?Â

Thats the problem I think, mine is the 4 plug. Â

Oh, thats different from stock. If possible, could you please post a picture/schematic of the pinout on the ecu? I now start to wonder what else is connected not quite where it should be.Â

Sorry, pin 2* on small connector?

Yes, I have reloaded with no luck. Which ecu pin is it looking for signal on? Pin 3 on the little connector?

Is it expecting 4.7v on closed throttle? Is it looking at all at the idle switch (4th wire on the TPS) or just looking at the initial start up voltage? Â I tried reversing the ground and 5v on the connector to the TPS, doing the same thin. Just sits at whatever value I select at the TPS SPAN and wouldn't change on throttle opening. Â

Hi again, I have obtained a hand held controller. While setting up the TPS SPAN the value doesn't change while depressing the accelerator pedal. The manual says to adjust it to 100 while depressing the pedal and then let it go and re adjust down to 10, but is the value on the screen meant to change in response to depressing the pedal after the procedure has been performed? Also, when setting the idle rpm, there is no change unless I change the solenoid duty cycle manually. The idle just sits on around 1000rpm. Can that be because the throttle position sensor is damaged or not adjusted to hit the idle switch?  Thanks

Thanks for that. Would it be appropriate for me to ask in a topic if anyone here has a second hand controller that they can sell me?

Great. I Â will send it in within a month. Can you please provide an address and a contact number? Â Also, where can I obtaine a copy of the manual for it? Thanks

Hi Simon, Â How much will the upgrade cost and how long can it take? Â Also I live in australia, what country will I be posting it to? Thanks.Â

Hi, I recently bought a Link G1 with a "WRX ROAD 97" chip in it. The chip reads: MC68HC711E9CFN2 5C47M SSFA9949 The board reads: Link  1996 Subaru v3.2 My question is, can I use a module and a laptop to connect to it? If so, what module and what software? If I can't use a laptop, what can I use and where do i get / buy it? Thanks! Â