Jump to content

Johann Maree

Members
  • Posts

    7
  • Joined

  • Last visited

    Never

Everything posted by Johann Maree

  1. What frequency do you set the Boost solenoid to for an Apexi solenoid on a G4 Xtreme?
  2. I need some help - I cannot find a way to disable idle ignition control so I can use the allocated table for boost control. I'm using PC Link G4 4.10.2.1784 on a G4 Xtreme. Any help please? Thanks!
  3. Johann Maree

    sr20 neovvl

    I had exactly the same problem with my G4 Xtreme on a RB25 - also changed the locked timing value and it didnt do anything on the timing light. For some reason I now cannot remember how I fixed it but I think there was some other calibration procedure that I also had to follow to get it right.
  4. Else, anyone willing to review my RB25 amendment attached (last 3 tabs in the file)?
  5. Just some extra information: I bought a G4 Xtreme early 2011 for my project car - an R31 Skyline. Then later in 2011 I found a complete R33 GTS25t front cut with unmolested wiring and stock ECU. So I installed the motor with OEM ECU and wiring and I've been driving it like this for the past 2 years.  Now I want to install a GT3071R and 1000cc Deatchwerks injectors, so the Link needs to go in now. I have an ECU side plug that will plug into the stock harness. I would prefer to use the OEM wiring as it is in very good condition and a lot less hassles than putting in all new wiring. As you can see, I already have the Xtreme, if I knew I would find a complete front cut then I would've bought a GTSLink as that is obviously the easiest way... If possible then a diagram like the above but specifically for a Series 2 RB25DET (ignitors built into coilpacks) would help me a heck of a lot! Thanks!
  6. Can anyone tell me if a diagram like the attached exists to wire a G4 Xtreme into a RB25DET engine harness? It should be fairly similar to the RB26 one attached? Getting my information in order to install a G4 Xtreme into a R31 Skyline with RB25DET. Thanks guys
×
×
  • Create New...