Jump to content

Ben Hainsworth

Members
  • Posts

    5
  • Joined

  • Last visited

    Never

Ben Hainsworth's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. New cap and rotor it fired straight up. Coil was relieving itself back into the igniter. Thanks for your help with this Simon, as usual very impressed with Links support and knowledge.
  2. I refitted the Mitsi one and operated the dizzy by hand with the plugs out. Have spark again out of coil but had poor spark on cyl's 2 & 3. Checked cap and rotor, both fubar, especially contacts inside cap. If gap excessive in the dizzy and the spark was being held up, would that load up the igniter and cause it to get hot?
  3. It had been sitting outside for a while and was a bit shitty looking so I modified my one. worked sweet testing it by hand but now it's cooking the mitsi igniter that's been fitted (J722T). I read the manual and it mentioned certain igniter types need to be hooked up to Trig2 instead of Trig1. I've got a stock Toyota one now as well, (same as in your 1uzfe diagram) can you confirm what trig to use?
  4. Previous owner had old engine still, lo and behold the dizzy only had 4 teeth...
  5. I've bought an AE101 Levin (20v 4age silvertop) it has a link ecu, it was running on this ecu. Previous owner ran it out of oil and replaced the motor. Couldn't get it to run, now I have it. Checking the basics the base timing appears to be out. It's firing well outside when it should (10deg after tdc). Timings all set up right, dizzy can only fit in one position. I was told it may be possible to offset the triggers by altering switches inside the ECU but can only see jumpers. Can you advise if this is possible?
×
×
  • Create New...