linklearner

Do you mean it will backfeed through the Relay Coil Circuit? I don/t have any spare Inj or Ign left and only have the AUX available should I Wire Pin 86 to a switch 12V feed?

bump

Hi guys, I'm currently wiring a NA 13B with a Davies Craig Electric Water Pump and a AtomX and are wanting to Drive the Pump from a spare AUX and wanting to know if it is OK to do it through a Hella Solid State Relay, in the Specs for the Water Pump it states current draw is 10A and the SSR is rated to 22A, is it safe to use one of these SSRs and if it is safe to use it in a standard Relay Holder on the Relay board in the Vehicle? Thanks

cool, thanks

HI, I'm wiring in a Link Fury G4X and am a little confused about the Lambda Sensor wiring, the sensor I'm using is A Bosch LSU 4.9 0281004821, just a bit confused about Pin 5 (Green), My sensor doesn't have a Green wire but does have a pin there, do I just wire the MES wire to pin 5 of the sensor? thank you, I know this is probably a real rookie question

Hi Guys, is it possible to load a Tune from a Plugin onto a Wire in ECU? Trying to do this onto a MonssonX Thanks

I'm pretty sure I did, but may not have , so next time I'm with the Vehicle I'll try it, Thanks heaps for your help.

I tried many times, I never saw any green bar, it would just come up with this error straight away.

Currently it has Version 6.16.27 and I'm unable to upload the latest firmware, I have included the error message I'm getting, any idea what might be causing me not to be able to update it? Thanks

I'm not with the Vehicle atm but I think the voltage was about 3.5V from memory, not too sure of the ECU Firmware sorry.

Hi Guys, I'm having a problem getting the calibration correct for the Temp Sensor in a Bosch 0261230340, when I have that calibration selected it read -40°C, if I select the Calibration for the Bosch 0280130017 it reads what looks to be pretty close, what am I doing wrong? Here are some pictures of it, the ECU is a Xtream, Thanks Jono

Hi, where abouts can i get the old manuals that used to be in the "support" section? Thanks

Hi, I have an old link ECU the number on the chip is LPV7 300701. is this bad boy pc tunable? i'm also wanting use this on a Toyota 4A-GE with reluctor pick ups, is this able to be changed to suit if so how much does it cost? and can I still buy a new Loom for it? Thanks