Jump to content

Kristopher

Members
  • Posts

    7
  • Joined

  • Last visited

    Never

Everything posted by Kristopher

  1. I have used that file I checked the out puts triggers and everything and the master hase to be turned up to 48 the car will start and idle for 5-9 seconds and cut out the injector duty cycle will just to 100+ after 600rpm.
  2. Ok so I went through the whole link book and did exactly what it says to do to get my car started and running. I'm using the rotary base map at 48 on the master and it starts right up idles for 5-10 seconds and then cuts all the fuel and leans out and while it is idleing above 600 rpm the injector duty cycle it well above 100%. If no one can help me fix this soon I'm throwing this ecu in the trash and getting a mega squirt.
  3. Well I changed the map and lowered almost everything and added the staged injection and it still goes wild on the injector duty but now it's after 1000 rpm and then cuts out all the fuel and dies I'm lost cause I don't have overrun fuel cut on cause I'm just trying to get it to idle then Im going to go back in and put all that stuff on
  4. could you do the firmware upgrade on the g3 to the g4 rx rotary ecu?
  5. and this is the run time data
  6. here is the pcl file and the last start with it
  7. on my 91 rx7 the injector duty cycle jumps over 100% after 500 rpm anthing below that is fine usually around 6-9% and because of that i can not get the car to idle. master is at 27ms, fuel table is at 23 for 0 rpm, 24 for 500 rpm, and 25 for 1000 rpm i have up dated the firmware,the injectors are simons 1600cc and the have 25w resistors wired on each injector. the car will start and rev to a max of 1000 rpm then drop like it lost fuel and i have loged it starting 5 times and to get numbers and everytime the rpm is over 500 the injector duty cycle is either really close too 100% or way over someone PLEASE HELP! 2nd.txt
×
×
  • Create New...