Alan Mullins

I have run with the map hose unplugged and the idle does not rise when i put my foot on the brakes. It was hooked up between the butterflys and the engine, Does this mean i need to hook it somewhere else Or is it a set up issue? Alan.

I am running tps Does the TPS need to set at 20-220 or is 20-100 ok? Regarding the hose where the map vacum comes from, Is that in the right place? Will it effect the idle? Thanks, Alan.

I am trying to get my GTIR to idle, when i do get it close it hunts very bad. The only way it will idle roughly is by lowering the master fuel to 65. Just noticed today that the idle rises when you put your foot on the brake, does this mean i have the map sensor hose in the wrong place? It is hooked into the throttle bodies, Each butterfly has a fitting so i have all four in series and then into the LEM. Is this wrong any help would be great. Alan.

The LEM is set at 10 degrees base timming, Can i set the LEM to 20 degrees base timming or do i set it at 10 degrees and put 10 degrees in the Edit Zone 0-10. If i can set it at 20 degrees should the Edit zone be set at 10 or 0? Sorry about all the questions, trying to figure out why the timming wont stay at 20 degrees. When i set the timming it seems ok but when i go and put a 40 degree limit in, The idle raises up and when i check with timming light it is way more advanced. Thanks, Alan.

I have tried to set the static timming, The GTIR has a timming mode, You disconnect the TPS rev the car 2 or 3 times above 3000rpm it then goes into timming mode and you set timming. When i do this the timming is way out. With the LEM do i just adjust with the TPS still connected or do it the nissan way? Thanks, Alan.

I am using the remote, It looks like a wiring issue with setting the TPS, Loose plugs etc I will try and set the static timming over the weekend. Thanks for your help. Alan.

I have a G1 V4 I am having problems setting the TPS scan. In the Utilities menu you cant adjust it.It has locked in at 255. Can you give me a step by step guide on how to set it, Can i just run a map or do i have to have map+tps? I also have the 02 sensor unhooked at the moment is that an issue, Its a gtir pulsar. Also setting the static timming, is that just a matter of entering a number. 20 degrees or do i have to do something else? sorry about all the Questions, Thanks, Alan.

Have got it running now, I just have bad Idle surge, Alan.

I have a G1 link in my GTIR. It winds over but it wont start. I think it is my Triggers, it says cyl=n and sync=n and cyl/sync err-0 Can you help Please? Is it just a set up problem or more serious? Thanks, Alan.

OK, it looks like o2 sensor, I will need that hooked up wont i? Thanks. Alan.

The white wire in the adapter loom has been cut, Can you tell me what it is for? Just bought this off trade me. A G1 with D42V4a on it, Is that a V4 model? Thanks, Alan.