Jump to content

Denis Tan

Members
  • Posts

    14
  • Joined

  • Last visited

    Never

Everything posted by Denis Tan

  1. Hi mate, For performance you throw away parts for emission control. The engine would run without EGR & secondary air pump. Denis
  2. Hi, Not mean to be rude, please explain what you need to know.
  3. Hi guys, Does anyone happen to have injector dead time vs voltage compensation for stock Toyota 1UZ injector. Any help much appreciated. Thank you. Denis
  4. Hi, Not mean to be rude, but have you tested the TPS with ohm meter ? That will tell you if you have bad/wrong type of TPS. And please make sure the pinout/wiring are correct for the TPS you are using. Denis
  5. Hi Jurgen, Thanks. Denis
  6. Denis Tan

    Ecu location

    Hi Guys, Do you know if we can mount G4 Xtreme & aftermarket auto trans controller(TCM-2000) next to each other in glove compartment ? Will there be any signal interference issue if I mount it this way ? Thanks. Denis
  7. When using a trigger wheel with 58 teeth and a gap where two teeth are missing (ie there would be sixty teeth if they were not missing), set the Tooth Count value to 60 and Missing Teeth value to 2. Note that this is generally known as a '60 minus 2' trigger wheel. Above are extracted from help in G4 software Denis
  8. I have it extracted as pdf somewhere in my other laptop, let me know your email so I can send it to you.
  9. You don't need batteries for knockblock on permanent install, if you want direct communication between knock sensor & ecu then go for G4 Xtreme, which feature knock control onboard.
  10. You need knockblock G4 knock control for G4 plugin. Denis
  11. Hi, I cannot seems to get this three wire Bosch idle solenoid operate correctly. I have set the frequency to 200hz, min clamp 20% & max clamp 80%. Wire in as per instuction manual to Aux 1 & 2. Idle speed fluctuate quite a bit with the same duty cycle in PC Link running status after drive.
  12. Select Multitooth/Missing, Missing teeth = 2, Tooth count = 36, Sync Pulse = No.
  13. Select Multitooth/Missing Missing teeth = 2 Tooth count = 36 Sync Pulse = No
×
×
  • Create New...