chris parnham

That's great thanks I've got the Vvt to do next , it's wired but finding info for when it switches in proving a pain aswell with converting it from ethrottle and finding dwell times etc I'm dragging this job out ...

Sorry it's a g4+ atomÂ

Does anyone have a base file for a lexus is200 1g-fe if not what's the best way to set it up ? it seems the triggers look like 1zz ones so am I right in thinking start with that and convert to 6cyl etc ? Rdgards chrisÂ

thanks simon ,just to say thankyou the update fixed the issue just  the conformation on the sensor , love the support but that is why ive just got g4+ for my other car regards chrisÂ

yes we might be on to something also i was under the influance mine had a 5.0bar internal sensor fitted but i can only select 2.5 and 7 haw can i indentify mineÂ

ive had the link g3 fitted on one of our cars for a while now ,i had a spare wideband controller so decided to fit this to it .its gone on fine and shows the afr's perfect but now ive been looking at the quicktune function and have issues when you open the function the 'target' afr isnt reading anything the 'actual' is reading great when you look at the target table the rpm goes from 0-65000 on the first box and finishes at 100000rpm how can i change the scale ? is the anything i could have set incorrect ,many thanks chrisÂ

ok i re-read the g4 and g4+ are under the same heading dont worryÂ

hi just recieved the atom g4+ from one of your agents ive installed your tech before but not this model , its says inbuilt map 2.5 map sensor on the spec list but theres not pipe on the ecu like the g3's etc is this a feature or am i overlooking something simple regards chrisÂ

i know its not a very commonly tuned engine but ive im installing it into an 1976 toyota cressida just after a base map if anyone has got one only a g4+atom for obvious reasons thanks for any helpÂ

sorry if this is a novice question i am new to this and everyone starts somewhere ,,, ive fitted your lem g3 to my rb25det ive wired it up got it running using the base maps its just running very rich i can only seem to increase the duty cycle but not decrease ? even when i change the master from 14 to 13 it just defaults back to 14 am i missing something simple or just doing it wrong my friend and i are setting it up on the dyno i just want to get a half nice before i get it there  many thanks chrisÂ

hi can i use the later spec2 self amplified coils with the g3 as in the fitting guide it only shows wiring for those with an igniter like used on the early spec1Â many thanks chrisÂ

ive just swapped the link ecu g3 from one of my r33 skylines to another r33 and it wont run ,ive not looked into it to much yet but there no spark for a start . one of the skylines is a spec 1 and the other is a spec 2 but i know with apexi power fc the same unit runs either ? i think the only real differance between them is the coil packs go from being amplified to self amplified but if anyone can help out that would be very helpful regards chris