justin sue
Members-
Posts
8 -
Joined
-
Last visited
Never
Content Type
Profiles
Forums
Events
Gallery
Blogs
Downloads
Everything posted by justin sue
-
should i replace that resistor with a lower value one or just drop the duty cycle of the signal from the settings menu of the ecu?
-
I currently have aux output 5 on my xtreme g4 hooked up to the tacho input, but it doesnt drive the MR2 tacho. what do i need to change on the MR2 tacho board to get it to accept the low level signal coming out of the link ecu since from what i understand the MR2 has a high level drive coming from the ignitor.
-
how big do you want the throttle body? i got a 70mm throttle body and a pedal up for grabs if your keen.
-
yea thats running the older version of the link xtreme with the inbuilt dbw capabilities, I have the later version and a E-throttle module add on.
-
yea its for a 2grfe. it should be possible to double up on the control valve aux channels but any differences between the banks like oil pressure or wear on the parts would produce a slightly different offset in the cam angle. would be best to let each cam dial itself into the target angle itself i would think.
-
is it possible to have quad vvt control and electronic throttle control via a e-throttle module with a xtreme? i got one of the later xtreme ecu's (red) with out the e-throttle control built in and a quad vvt engine. the 4 vvt oil control valves need to be wired into aux 1-4 but signal 1 for the e-throttle module needs to be wired into either aux1,2,3 or 4. can signal 1 for the e-throttle module be wired into a different aux channel?
-
ive got my 4agte blacktop 20v with 4agze bottom end started and im wondering if anyone has a map i can use to save time on they dyno tune next week thursday. can you please contact me asap at [email protected], thanks in advance regards justin
-
hi im currently wiring up my 4agte 20v motor and im just wondering if i need to use the 8V or 5V power for the CAS inside the distributer. for the sensor grounds do i need to run the earth back into where the black sensor ground comes out of the ecu then run the two ground wires separately to the engine block. or can i just earth the sensors together in one spot and run the 2 grounds from the ecu to the engine block?