Guy Zahratka

Hi Scott I figured out my problem with the triggers, they were adjusted wrong (to wide of a gap). I readjusted both triggers to factory specs, now engine starts and idles great. My issue now is when I open the throttle the engine dies. It seems like it is not getting fuel. Throttle position sensor is working and reading correctly, map sensor is reading correctly. I don't think the injectors are opening up. I'm running low impedence injectors. When I use injector test on link G3 I can hear them working. When running, I do not think they are opening more then enough to idle the engine. Engine will not rev up. I must be missing something. Any help? Thanks Guy

Hi Scott, Triggers have signals and I have spark but when I install plugs in head, I lose both cam/crank signals and spark. I have a distributor with both cam and crank sensors in it. Â This is a Toyota 4A-GE 16 valve silver top 1600 cc. Â I have 2 stock engines both have same distributors. Â 4 tooth and 1 tooth in distributor. When turning over without plugs in I have signal 1 & 2, but they flash on and off when turning engine over. Â RPM reads on and off also, turning over 375 RPM to 0 back and forth while cranking over. I have link set on after #1 Â - 1 tooth per tdc - cam. Â Engine will not run. Â What is it that I'm doing wrong? Â I lose both signals even with coil unhooked (have good battery) and plugs installed. Â Engine turns over normal speed. Thanks, Lost Guy

Im running or trying to run a g3link on a toyota 4a-ge with a distributer 4 tooth and 1 tooth reluctor pickups in distributor. I cant seem to get these set up right.Trigger 1 is 4 tooth trigger 2 is one tooth. Any help Â

Unable to get G3 to connect to PC. I get this message. "Unable to connect to the ECU. Please check that the ECU is properly connected, the power is turned on and the correct COM port has been selected."    I'm using a USB cable. Key is on.  In options the serial port is set to Auto. I have re-downloaded the PCLink software (version 3.4). This is the first time I'm attempting to get a connection (new setup). Any help is appreciated.Â