infini iv

 Hi Guys  Im hoping you may be able to help, im using a link G3 (that has been upgraded to G4) and wish to use a LC1 wideband device connected to the ECU. I understand this must be connected to one of the analogue inputs but arent sure which pins of the ECU are these analogue inputs. I have searched the G3 manual and they are not listed there, do you have any info regarding which ECU pins are unused analouge inputs so as i can connect my LC1  Regards

Problem sorted by the guys at DTECH Motorsport all remotely via the PC. these guys are legends and i cant recommend them enough. the service they provide  is outstanding and second to none. A real credit to link having them in your dealer network

Looking at my problem it appears the ECU is trying to flash the codes to the CEL but instead is driving the main relay hence why i get a long click of the rlay  (and fuel pump prime) followed by a few short ones. Any ideas

Does anyone have a base map from a evo plug in G3 that has been upgraded to G4. apparently their are considerable differances in the set up. Alternatively if i just use an older version of pclink can i just flash the older base map that comes with it or will that remove the firmware upgrade also??

happy to donate some beers via paypal etc if someone has something available.Â

Does anyone have a base map from a evo plug in G3 that has been upgraded to G4. apparently their are considerable differances in the set up. Alternatively if i just use an older version of pclink can i just flash the older base map that comes with it or will that remove the firmware upgrade also??

Hi all, new to the link having previously used remapped factory ECU's. i have purchased a evo plug in G3 ECU that has been upgraded to a G4, im being told by the seller (havnt received it yet) that it will come with no map. Is there a 'base map' available to load to the ECU so the vehicle can be started I had contacted simon at link to ask about G3 upgrade to G4 as opposed to going straight to a G4 plug in and he mentioned some level of complexity due to pin configurations or something??? any advice or info appreciated