jim bennett

i have a rb25det installed in s14,if i purchased g3 plug and play would it use the maf on the car or would it go just by the on board map?on another note i am in the us and a client has 06 wrx sti he wants g3 but question is will it support ob11 diagnostics?

I have a rb25det installed in s13 using a LINK G2.At 1100 rpm I turn the cam solenoid on at 5700 it turns off.I have no dyno sheets to show but seat of the pants is very noticeable.Check out www.gtr.co.nz they have dyno sheets to show their research.

i have an rb25det with variable timing solenoid,does anybody know at what rpm it should be activated and deactivated?

what kind of engine do you have ,would this be the same for rb25det?what is the gain from retarding are higher rpm,?is it the intake,exhaust or both?

link g2 on rb25det,engine will exceed soft and hard limits of rpm,promp comes on laptop screen acknowledging limit exceeded,when flat shift laptop says ok but rpms keep going no cut out,launch control will not set at desired rpm,just keeps reving, whats up?what do i need to check,or set up different. thanks

reload update transfer fies everything good now thanks

i now have rotating link,have transfered files from 3.1 to 3.11,but have no spark or injector pulse.rpm crank is 168trig 1 is yes trig 2 is yes.have set on 1 tooth and cam yes.all fuel and ig tables look the same but no start.any ideas?

i have link g2,installed on rb25det in a s13,was running perfect until i tried to install firmware updates.original firmware was 1.1.27 installed the latest 2 and added pclink3.11 now car wont start.what did i do wrong.the rotating link symbol in upper right hand corner does not rotate anymore.what should i do now?