I have a Link G4 extreme (serial 12xxx). I have a Bosch M4 motorsports ABS unit and Bosch DDU7 dash. I have connected the DDU7 and M4 with the Link G4 by the CAN bus connector. The DDU7 sees the data from the M4. But I have not been able to get ECU data to the DDU7.
Â
Here is the Link configuration. It is the generic dash setup:
I have confirmed that the DDU7 is communicating with the M4 ABS and the yaw sensor over CAN. They are communicating at 1 Mbps.Â
Here is the DDU7 CAN input setup page. I believe 3E8 hex is 1000. For RPM I set the multiplexer value to 0. I have tried with the extended box checked and unchecked, it does not work either way. Do I need to change the endian settings? Or what do I need to change?
Â
Hoping someone can help.
Â
Richard Luciano