scott mcqueen

so i figured out that it has something to do with the trigger? maybe lol, andway, when i change it from rb26 trigger to rb20 trigger it runs fine, that increases the eccs widest slot by 1 aswell i think

motor is rb26/30. link g4 plug n play anyway, was tuned on the dyno, everything was all fine, noticed it didnt idle very nicely and was a bit hard to start but didnt think much of it. went to drag strip and did run down strip all fine with no hassles. went to do sencond run down strip and cudnt start it, would just turn over. managed to get it to start by tighten a loose earth wire. did second run down strip and then when i tried to do 3rd run, couldnt get it to start again. managed to tow start it and now it wont rev below 2000rpm. starts perfectly fine on standard ecu and idles