toby rodriguez

I only get on o2 oxygen number when the car is warming up but after that only when I press on the accelerator do I get a reading from the narrow band, Is this normal?

I have a 2000 subaru impreza rs, with a Linkplus v10 ecu. I'm confused about the narrowband o2 reading. Before I had a vaccum leak I was getting a 0.00 oxy reading at idle. Should I be getting an o2 reading at idle? Or should I be getting an o2 reading when I press the throttle? Should I be getting an o2 reading the whole time the car is on? Is there such a reading of 1.00 oxy reading?

ok...but the stock ecu seems to use the both fans but I guess it doesn't on the link.? The overheating must be something else, I'll have to change the thermostat. As of right now my car wants to run at 190 - 195 F.

I have an overheating problem. I have a 2000 subaru impreza RS with pnp link. Only on3 radiator fan is turning on. When I put the stock ecu back in both fans turn on. So I think the maybe the Pnp harness is not wired right. Do you have a diagram for the pnp harness and stock harness so I can figure out which wires belong where?

So I got it started but still back fires on initial startup. I do change the rear narrow band to the front bung and move the other one to the back? Do I leave the Subaru wideband o2 sensor disconnected or do I connect it?

Forgot to mention that it has a larger fuel pump. I did relocate the rear o2 sensor to the front and left the other o2 sensor (wide band) disconnected. I just have my down pipe hooked up.

I had zone 100 set at 0 fuel and 0 timing.

I have a 2000 subaru Impreza RS ej25 with bolt on turbo kit, high lift cams, pnp linkplus v10. I have larger injectors 440cc. I was having trouble starting at first. I did have zone set at 0 fuel and 0 timing and it would not start. I added fuel and timing in that zone but now I get back fire when I start it up but when I get it started it idles in zone 120. I have idle set at 900 rpm.

I can't help you, but you can help. Can you send me a copy of your map? I just need the v10 software. I can't seem to get the newer v14 to work on my link.

I'm having trouble starting using the newer v14 software, am I missing something? It doesn't seem to be reading the narrow band oxy sensor. It starts with the lem v5.