david henningsson
-
Posts
4 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Downloads
Posts posted by david henningsson
-
-
problem solved. weak ground on pin2. good spark and the car has started.
-
if i have the sparkedge wrong it doesnt click in the coil. ivé tried. ivé tried both without and with the spark plug touching ground. no difference. pin 4 and pin2 is grounded to enginge but in two different places. many other i have talked to only have the pin 4 grounded if the coils metal doesnt touch the sparkplug. and that works. i am going too draw 2 new ground plus 1 new engine ground from chassi just too be sure its not that.
-
Hello. i mounted 6 vag (06b905115r) coils on my bmw m50 turbo. built in igniter. Pin1-12v Pin2- ecu ground. Pin3-ignition drive from ecu. Pin4-ground too engine. doing an ignition test and i hear the coils click but there are no spark at any of the coils when i have spark plugs too check it. WHY? i have rpm and trig 1 and 2 signal. about 180-210 rpm while cranking. Very thankful for quick response. With best regards David Henningsson, Henningssonmotorsport.
ECU fault or wiring?
in ViPEC V Series
Posted
Hello. My friend has a v88
and when we measure 12v and ground it is ok on A. But on B we get 12v on the ground. Note. We have only connected A and B 12v + and grounded A. B is not grounded to car. And there we get 12v+ on the ground. ?
Also has 12v out from inputs when harness is connected.
The harness is correct now. But before it was connected vr sensor signal with 5 volt out to sensor and ground from sensor was connected to ground into v88.
Did this brake the v88.
When harness is connected to car it anv2-3 change to Anv at 5 volt.
And measueres 12v anv2 on signal cable from v88. ? What is up with this.
It is a home made pnp with original Bmw harness. M43.