Jump to content

James Fitzpatrick

Members
  • Posts

    8
  • Joined

  • Last visited

Everything posted by James Fitzpatrick

  1. My memory must be off. Perhaps it was limited in space. Never the less I will just have to ensure I remember to start/stop data logging without the display prompting me.
  2. From memory the old G4 doesnt have internal memory for logging, so I may as well remove this parameter from the display then? Thanks again for your help thus far
  3. Thanks Adam, got the display to work with AN Volt 5, which had the 150psi TI sensor connected. And changed the MAP display to MGP PSi which all works well. However still no luck with Logging status. See the attached image, where you can see down the bottom left of screen that the PC Logging =Record, but the status doesnt change.
  4. Hi Adam, thanks for the quick response, I will give that a go tonight. Just to save me some time, where do I get to the Calibration tables, as thus far I have been looking in the properties for each parameter. As for logging, yes using Logging Status, I tried the 'Old' alternative just to check, but no change.
  5. Hi Adam, I'm looking to do the same, displaying pressures in PSI, but am using an older G4 link, and a tablet to display. I can't find any 'Units' under options to change from metric to imperial. When looking at the properties of each display parameter I can select auto or manual settings for where warning values are set etc, but nothing to do with the units. Using V4.10.2.1784. Also, one of the parameters on the display is the Data Logging Status, so I can see if I am actively data logging or not, however when recording, the parameter display remains OFF. Any advice would be great!
  6. Hey, sorry to reply to an old thread. But am hoping to touch base on this topic, particularly with Tenny to see if the Pipo tablet worked out with the OTG hub for power and data connection at the same time? I'm looking to fit a similar tablet myself shortly and would like to know how his project had worked out! Cheers
  7. Hey, Just in the process of wiring up an RB30det, and was wondering if it is possible to use the g4 ecu to monitor the oil pressure and protect the motor should oil pressure drop to damaging levels. Wether it be by putting the motor into a limp mode and display a warning light etc? I'm asking as I've been told its possible to have a limiter come in if the air fuel ratio goes outside of set minimum/maximum values, and thought it could be useful for oil pressure too. Any suggestions would be great. Thanks
  8. Got a R32 gtst, using plug in g4 ecu, has onboard map sensor....What happens to the un-used afm sensor plug? Do i just tuck it out the way?
×
×
  • Create New...