razzmtazz
-
Posts
38 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Downloads
Posts posted by razzmtazz
-
-
so update car is not starting on the above settings if i close
the cam sync it starts up
Trigger Scoper33gtr - 2023-11-2 11;55;37 pm.llgx r33gtr aem 24.pclx
-
Thanks guys for the help it works but muli had to be set at 1.6 for full sweep
-
12 minutes ago, AbbeyMS said:
the factory speedometer sees the signal from the output sensor in the gearbox before the ECU. With a little wiring you could rewire the set up to do what your trying to do. Output sensor = ecu - speedometer
Yes it's now sensor to ecu and to ecu to speedo have not driven the car but the pwm test doesn't work and no sweep also
-
hi
i am trying to run the factory speedometer through the g4x plugin ecu to correct an over speed reading issue
but the speedometer does not respond to the pmw test
help would be appreciated
-
Hi
Guys I need help setting up aem cas trigger disk on my r33 gtr the car is starting on the base map but feels like not running right
thanks
-
Hi
Guys I am trying to configure a over ride button on my can keypad for fans and fuel pumps if I want to run them regardless of the default parameters but can't seem to get them to work
Any help will be appreciated
Thanks
-
21 hours ago, Adamw said:
What is it being used for? From memory it had CAN DI1 on it which is not assigned to anything?
It's speed input as car is auto so seed based boost control
-
On 3/27/2023 at 4:56 AM, Adamw said:
The GP boost table could be used to adjust what is being commanded by the blended tables.
Can you please explain?
Just now, razzmtazz said:Can you please explain?
As you see it's already being used
-
hi
i just installed a can keypad and want to increase boost through the can keypad
but i dont want to change settings which are working fine so is there a way i can setup an other axis for the can keypad?
-
Hi
Guys I need help to setup bottoms on the can keypad for boost engine state launch control etc can please someone give me a basic guide on how to do it
Thanks
-
hi
guys i am having trouble getting stable boost with duel boost maps and having ethanol content as axis on the second map
please help
-
Password is razz123
I have put all the injector details engine etc
-
hi
guys i have a link evo 3 plug in g4x in traditional it runs fine but as soon as i try to modelled it doesn't want to start cant figure out whats going on thanks for the help map is attached
-
Hi
We just installed a link g4+ for evo 9 plug in everything is working turned the sweep on the rpm gauge but it does not do any thing but as soon as the engine is running it works fine need help thanks
-
Thanks
-
hi
i am in a process to install haltech ic7 on a evo link pnp have can to pcb connector 101-0022 and can cable for custom display 101-0019 but dont have any type of instructions nor pinouts
need help
-
Thank you
-
It's for a evo but need to know if it's a g4 or a g4+?
-
Hi guys need to identify this ecu please help
-
-
Hi
I am in a process of wiring in a extreme x to a evo 5 with e throttle need pinouts for it help will be appreciated
-
Thank you guys
-
would also like to know an volt 1 location
thanks
-
hi
trying to config a evo 9 plug in but cant seem to find di8 also two aux3s and to ign4 present on help file pinouts
Need identification
in G4x
Posted
Guy need to know if this is a g4x or a g4+