Vate

Thanks Simon for the Audio files. (I found them) They certainly help! Gavin

Thanks Simon for clearing that up. Fortunately I have a spare MAP sensor on the shelf that I can wire in.

Thanks. Sounds like I will have to get back to Link as I was given the impression that it did!

Sorry, Haven't got time for that at the moment as we are about to go out to my wife's Xmas do, but it is the same as the one that is advertised on this link: http://www.trademe.co.nz/motors/car-parts-accessories/performance/electronics/auction-1211294241.htm Part # G4+A (All black with yellow Atom emblem) PCB REV V1.4

I have just bought two G4+ Atom ECU's and the "G4 Wiring and Installation Manual" says this: "Storm ,Atom, Lightning and RX ECUs have an internal MAP sensor. If a higher pressure is required than that of the internal MAP sensor, an external MAP sensor can be wired to an Analogue Volt input. To use the internal MAP sensor connect the MAP pressure hose to the barbed fitting on the ECUs end plate." Problem is there is no 'barbed fitting' on the ECU's end plate! What gives????