Vapor
-
Posts
7 -
Joined
-
Last visited
Vapor's Achievements
-
Vapor reacted to a post in a topic:
Setup Analog to Can Converter
-
Vapor reacted to a post in a topic:
CAN Setting LCS file
-
Thank you prompt reply Adamw. I'm sorry, I made a mistake in sending the enclosed file. The E-Throttle 2 setting in the original file was "On". However, I wanted to idle the engine, so I changed the E-throttle 2 to off. I tried the E-throttle setting procedure many times. E-Throttle 2 was able to operate in E-Throttle on setup mode. However, E-Throttle 2 did not work after E-Throttle mode was turned on. As you may have noticed, I have confirmed that the Aux15E throttle relay is open. It happens after a few seconds when the ignition is turned on. It uses one by one external relay for both E-throttles. Aux 12 and 15 control each relay. Therefore, the final supply voltage for the Aux17-20 will be 0.00V. The cause of "Aux15 E-Throttle relay is open" was not found. Thank you for suggesting to create a log file. However, the 4-rotor engine is taken out of the car and checked inside. I will report the results in a few weeks. Again, Thank you for your support.
-
My friend try to start 4 rotor engine by thunder G4+. The specification has 2 unit of e-throttle of genuine RX-8. But one of single e-throttle is work normally but other one is not work and error. Would you mind advice me enclosed pclr? G4+ Thunder Sample_4rotor-shoki-4.pclr
-
Hi Adamw, Thank you for prompt support. OK, I am going to be connect sensor ground as you noted.
-
Hi, I have been making a wire harness for connect G4+ Storm with FD3S. Is there need to use to connect the "GND out" pin? What is need to connect pin for "GND out" if it neet to connect?
-
Hi, I could confirmed and tried your vest solution. Thank you very much for your kind support.
-
Hi Scott, Thank you very much for your prompt reply and kind support notice. I look forward to fixing the issue. Vapor.
-
Hi, I'm going to use G4+Storm for FD3S. I have been to make a configuration change 4 cycle to rotary. But in ignition tab could not display the trailling sprit map. All other units can display it when I had tried same configration change. Can't apply the trailling sprit map in rotary configration of G4+Storm?
