Rosello
Members-
Posts
21 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Everything posted by Rosello
-
Why have 2 can module if we can put obd2 only on 1 can module?there is no solution?
-
I have ecu plug in g4+ for nissan skyline r34 gtt, and my boost controler is plex tuning pbc he needs obd2 for protection (afr,egt)
-
I found why it does not work, my output can2 has a problem does not work
-
I have ecu link g4+ and i have obd protocol wifi on can2 but on can1 i have a boost controler my preparator has parameter can 1 on obd
-
J'ai essayƩ de cliquer sur ok et c'est fait pareil
-
I have tested to activate 2 can and i can't activate
-
Ok thank you, i don't know if bit rates is same.
-
Ok thank you but it is possible to make it work two can module or only one?
-
Hi guys, it's possible to make it work two CAN module (CAN 1 and CAN 2)? or only one CAN module can work? because i have a boost controler and a display to connect thank you.
-
F...k!! thank you
-
I have a probleme where is can setup?
-
"No you do not need to connect to the ECU ground. The 12V and GND is only needed to power the wifi device, it is not needed for communication. " Are you sure?because look it's write "connect to ecu signal ground"
-
Ok thank you i'm going to try
-
ok thank you so much, but i need modify mode?
-
Hi guys look my picture thank you for your help
-
My tablet is android and is not possible work with usb, i need interface obd2 wifi but i can't connect my interface wifi OBD2 at the ECU?
-
Yes i would like connect my ecu g4+ on the tablet but the ground of the ecu(pin1) is not connect on the wiring i do connect on the ground or not?
-
Hi, the ground of ecu mest be connect or not?thank you