Jump to content

damla

Members
  • Posts

    6
  • Joined

  • Last visited

Everything posted by damla

  1. damla

    Speedo issue

    hi Adam, i feel like an idiot but i didnt even see the settings window for that input come up! ive changed to rising edge and adjusted value and it looks good now. thanks for your help.
  2. damla

    Speedo issue

    i have link g4+ gtr plug in ecu in my cefiro. the problem im having is that the signal for the speed seems erratic. my speedo is cable driven from the gearbox to the speedo cluster and then goes from the cluster to the ecu, i have yet to trace the exact route. if i create a digital gauge in pclink using LR wheel speed DI3 i see the speed (its half of what it should be but i can correct that on the dash im using), every few seconds it seems to jump to about double the speed im doing for a fraction of a second, so if im doing 50kmh it shoots up too around 100kmh. im outputting over CAN to my dash and i see the same thing over CAN as i do i pclink. keeping in mind that the factory cluster seems to operate as normal with no fluctuations. have you encountered this before with cable driven speedos? do i need a resistor inline with the signal to the ecu? any help appreciated. regards Damian
  3. do you know if anyone has had any issues with the aem 150psi sensors being stamped 150psi but actually being 100psi? ive connected one to my fuel pressure but when i setup the calibation as per the 150psi sensor it reads quite a bit out from my mechanical gauge, if i change the calibration settings to suit the 100psi sensor it reads pretty damn close to the mechanical gauge. ive tried using cal 4 with input a 0.5v input b 4.5v output a 0psi output b 150psi and using cal 10 with the values from the aem sensor calibration sheet, and the both read the same incorrect value. i know its not a link sensor but thought you may have encountered this before. cheers.
  4. excellent, thank you. also with the xs expansion header #1 pins 7 & 8 are labelled an temp sensor input, does that mean i can connect an 5v oil temp sensor to this? im putting in oil and fuel pressure sensors that will be connected to pins 5 & 6 (an volt 8 & 2) and hoping i can connect temp sensor to 7 or 8 to avoid a second expansion loom at this point.
  5. quick question, for connection of analog pressure/temp sensors etc what cable type/size is recommended? im assuming screened is best option or does it not matter for connection of these sensors? and size wise is 0.25mm2 cores ok or should i go 0.5mm2? apologies if this has been covered but ive had a search and cant seem to find it, new to the link world so go easy on me . Cheers in advance.
×
×
  • Create New...