Jump to content

Search the Community

Showing results for tags 'dwell'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Link
    • G4+
    • G4x
  • General Topics
    • Guest
    • WishList
    • Engine Tuning
    • Customers Vehicles
  • Vi-PEC
    • Vi-PEC i Series
    • ViPEC V Series
    • ViPEC Power Sport
  • Historic Products
    • Link G4
    • Link G2 G3
    • Link G1


There are no results to display.


  • Bryan
  • 카지노 사이트, 카지노 추천«TSG79.COM
  • 2JZ Tuning Tips

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







ECU model

Serial Number

Found 3 results

  1. Hi all I'm trying to find the correct deadtime for pink sti top feed 550cc that replaced my old RC 440 on my 4efte tuning my g4+ ecu Also went to COP conversion setup, so I've used the Toyota/Denso 90919-02238 from 2zzge, so can someone help with the dwell table, which I guess are the same as 90919-02230 Thanks a lot Regards
  2. Hi Guys, Link G4+ Thunder I want to run Bosch coils on plug and they require 73mA each to run them I will run 6 of. Is that with in the ability of the Link ECU to run them. Attached is the tech doc from Bosch in case I have read something incorrectly. Single_Fire_Coil_P65-T_Datasheet_51_en_2777882763pdf.pdf
  3. I've modified My Evo to run sequential [direct] spark with a set of 4x Denso 90919-02229 coil packs from a 1L Toyota Yaris, but I can't find any information on the dwell times to adjust the 3D table. I am GUESSING that the Toyota Altezza (IS200 in UK) will be the same, or near as? If anyone's interested, hardwiring the mod was simple enough, just 2 extra wires from the triggers to coils 3 and 4 back into the cabin (i also used an extra 2 pin plug in line to make removal of the coils easier), remove the Fuel pump and BOTH A/C fan wires. Then pop the new wires into their place, move the High sp
  • Create New...