Jump to content

Strom wire in help


razzmtazz
 Share

Recommended Posts

Hi I am in a process of wiring  a strom black wire inn to a 2jzgte vvt have two problems at the moment one there is no start up calibration in the base maps for the 2jz vvt an other is there seems to be no idle control valve how to control idle?

Thanks

 

Link to comment
Share on other sites

You could use The Toyota supra map as a start, it's for a 1jz so not a million miles away.  Check ignition settings wasted vs direct. 

I'm guessing your engine was e throttle which would have controlled the idle and has been converted to manual.  You will need to set the base screw on the main throttle to give you cold idle, and then set up the idle ignition table.  It can be a bit tricky to get good idles at cold and hot without an ISCV but it is doable.

You'll probably need to bit a bit more aggressive with the values in the idle table.  Add 2 lines to the idle table. One for cold and one for hot, these will then give you the span of engine temperatures. 

HTH 

Richard. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...