Fotis Posted June 30, 2019 Report Share Posted June 30, 2019 Hi everyone, can i use my stock OEM knock sensor to work with Link ECU G4+ or do i need a controller? Thanks! Fotis. Quote Link to comment Share on other sites More sharing options...
Simon Posted July 1, 2019 Report Share Posted July 1, 2019 Assuming the ECU you have supports knock then it is just a case of wiring it to the ECU. Quote Link to comment Share on other sites More sharing options...
Fotis Posted July 1, 2019 Author Report Share Posted July 1, 2019 I should wire it as a knock 0-5V Analog? Quote Link to comment Share on other sites More sharing options...
Simon Posted July 2, 2019 Report Share Posted July 2, 2019 There is a dedicated knock input on ECUs that support it. What G4+ ECU are you working with? Quote Link to comment Share on other sites More sharing options...
Fotis Posted July 2, 2019 Author Report Share Posted July 2, 2019 Its a pnp link g4+ 96+ HC. I havent seen a dedicated input on the manual. Quote Link to comment Share on other sites More sharing options...
Simon Posted July 2, 2019 Report Share Posted July 2, 2019 96+ is all set to go it is expecting the knock signal on pin D6. Quote Link to comment Share on other sites More sharing options...
Fotis Posted July 3, 2019 Author Report Share Posted July 3, 2019 Awesome thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.