Jump to content



Recommended Posts

I've got a G4+ Supralink, can you use stock knock sensors? I've got a Link knock sensor but the stock loom has 1 pin, the Link one has 2 so how do you wire them in?

 Also Ive got an oil pressure sensor, its got a 3 pin plug but the stock loom has a 1 pin plug so how do you wire that in?



Link to comment
Share on other sites

Stock knock sensors are fine to use they earth through the sensor body, Where as a 2 pin requires a ground to be connected to it.

Stock is an on off type switch so is open circuit or to ground, the 3 pin sensor will do a 0-5V output and will require 5V and ground to operate. The signal will then be wired to a AN volt input



Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...