Pete_89t2 4 Posted November 19, 2019 Report Share Posted November 19, 2019 Hi, I just purchased a '93 RX7 that is running a Link G4+ Fury wired in ECU. Since I'm going to need to modify & rebuild the wiring harness to add some features that the prior owner didn't use, I was wondering if anyone can point me to the correct industry part # for just the replacement terminal pins used in the AMP super seal A & B connectors used on my Link Fury? If these are industry standard terminals, I could probably get them from Mouser, Newark or one of the other big online electronics parts suppliers. Cheers, Pete Quote Link to post Share on other sites
Adamw 1,151 Posted November 20, 2019 Report Share Posted November 20, 2019 You can get a few different variations but the common ones are: Gold plated for 20awg wire 3-1447221-4. Sometimes the similar 1437284-9 (gold 18-20awg) is easier to get. Gold plated for 16-18awg wire 3-1447221-3 Quote Link to post Share on other sites
Adamw 1,151 Posted November 20, 2019 Report Share Posted November 20, 2019 Added later: Forgot to mention, the best low cost crimper that will do a decent job on them is the 1026 CT Quote Link to post Share on other sites
Pete_89t2 4 Posted November 20, 2019 Author Report Share Posted November 20, 2019 Thanks Adamw - That's just what I was looking for! Quote Link to post Share on other sites
nachollamg 0 Posted April 6 Report Share Posted April 6 Hello, what about 3-1447221-5 for 22 AWG cable? It says it´s also for AMP 1.0 Superseals. Would be suitable as 3-1447221-3 and 3-1447221-4 are? Quote Link to post Share on other sites
Adamw 1,151 Posted April 6 Report Share Posted April 6 If you have 22awg or 0.35mm2 wire then the -5 terminal will be good. The Link looms only use 0.5 & 0.85mm2 wire however so the quoted -3 & -4 are the correct pins for the Link loom. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.