Jump to content

Recommended Posts

Hello, i have wired up can Lambda to my snowmobile-engine. I have followed the instructions for software in the help section.

I have not started the engine, but i have a handheld starter and it turns it at 650 rpm. Gauge( Lambda1 shows nothing on my pc, and sensor does not heat up.

Any ideas?

 

Link to post
Share on other sites

How to record a PC log and save the map:  https://www.youtube.com/watch?v=_P1LRANeO4A

Spinning it on the starter motor likely wont be enough.  From memory it wont start heating for about another 15 seconds after it sees RPM.  

You can go to the runtimes screen (F12), then ECU status tab, Lambda 1, and check status there.   

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...