Jump to content

Altezza 3sge Starts & Revs, but no idle.


kenkko

Recommended Posts

As the title, i installed a link g4 plugin on a completely stock 3SGE and set up the throttle sensors for the ethrottle. I am using the stock MAF on the basemap included in the tuning software. The throttle sensors and MAF sensors make logical sense, which has got me confused as to why the car wont idle. It will start up, and can rev a little bit, but when you get off the accelerator, the car stalls. Tune file attached. Any help would be appreciated.

Thanks.

002 system.pclr

Link to comment
Share on other sites

The base map is set up to use MAP, not MAF.  Assuming you have connected a vacuum hose to the MAP sensor, then set AN Volt 11 to MAP and the calibration to 4 Bar.

You also need to set your injector size to match whatever you have - it is currently set to 900cc which is unlikely on a stock engine.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...