Oopsonair Posted May 9, 2020 Report Share Posted May 9, 2020 My customer has MoTeC LTC. How to setup in G4x software? Thanks for advance. Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 9, 2020 Report Share Posted May 9, 2020 The .lcs templates are in the process of being updated so you wont find them in the software yet, but I have attached one to this post for the LTC. For the CAN set up follow the instructions below. Also, in the analog inputs section of the software, navigate to the Lambda 1 menu and set Lambda Sensor Control to "Link CAN". Motec LTC 1120.lcs Quote Link to comment Share on other sites More sharing options...
Apex Speed Tech Posted May 23, 2020 Report Share Posted May 23, 2020 Hey guys, I'm not getting anywhere with this UTC. I followed these directions exactly, all I get is the Lambda1 value flickering occasionally from 0 to 6550 and back. Any ideas? Its a brand new LTC from MOTEC, a brand new AtomX from Link. Checked wiring, there are term resistors at both ends, nothing else on the bus, its at 55ohms. Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 23, 2020 Report Share Posted May 23, 2020 Can you attach the tune, Ill take a quick look. Quote Link to comment Share on other sites More sharing options...
Vaughan Posted May 24, 2020 Report Share Posted May 24, 2020 Make sure your Lambda 1 source is set to Link CAN Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.