G4 X CAlibration MAP sensor 4b Omni error & Error Code 9

[Bud]

Hello

I start to confguration costumer car with Plug In Subaru WRX9 G4X

i have Error fault number 9, what is it?

 Also I have some error and some problem for calibration for MAP Sensor Omni power 4b

i try to cal 1 or linear cal 1 with 0-5v & 0 - 400kpa

when i try to calibration some error show me

Some idea of problem?

i join base map if you need

regards

Subaru WRX V9 G4X Xtreme Plugin base map 01.pclx

[dx4picco]

The pressure sensors I know are 0.5-4.5V and not 0-5v.

I don't know the omni particularly but I suspect it would be the same.

try and rescale 0.5-4.5 for 0-400kpa

[Vaughan]

error 8 & 9 area debug thing which show if a value has been set higher or lower than it's expected range, update to the latest firmware and clear fault codes. (They no longer cause a fault code in the newest release)

That error window is because you can't calibrate a sensor that is too far out, if the sensor is more than 5kpa different from BAP then it is considered to be either faulty or set to the wrong calibration.

[Bud]

On 5/11/2020 at 9:19 PM, Vaughan said:

error 8 & 9 area debug thing which show if a value has been set higher or lower than it's expected range, update to the latest firmware and clear fault codes. (They no longer cause a fault code in the newest release)

That error window is because you can't calibrate a sensor that is too far out, if the sensor is more than 5kpa different from BAP then it is considered to be either faulty or set to the wrong calibration.

Thanks Working well