David Anstis Posted August 1, 2020 Report Share Posted August 1, 2020 Installing a new Link G4X with A & B looms, into a K20a Kswap EG Civic. Intake and exhaust sensor wiring...what inputs are used? Digital??? With the coils and injectors, do I use an Aux feed or and ignition feed? Cheers Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 1, 2020 Report Share Posted August 1, 2020 Pic from the help file below should answer most of it. Note the extra relay it shows for the lift solenoid wont be needed if you are doing custom wiring - that is only needed if using a factory K20 engine loom which triggers the positive side of the solenoid. Just wire the lift solenoid the same as is shown for the inlet cam position solenoid. Injectors 1-4 go to INJ 1-4 drives. Coils 1-4 go to Ign 1-4 drives. Quote Link to comment Share on other sites More sharing options...
plumflies Posted November 25, 2020 Report Share Posted November 25, 2020 On 8/1/2020 at 1:50 PM, Adamw said: Note the extra relay it shows for the lift solenoid wont be needed if you are doing custom wiring - that is only needed if using a factory K20 engine loom which triggers the positive side of the solenoid. Just wire the lift solenoid the same as is shown for the inlet cam position solenoid. Hi Adam, silly question because first time doing a wire: do VTEC and VTC solenoids need to be fused? Thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 25, 2020 Report Share Posted November 25, 2020 Yes, pic from the help file below. Typically any relays any solenoids would be connected to the main relay which is fused. This will typically be 10 or 15A depending on how many injectors are connected. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.