Cemicks Posted August 17, 2020 Report Share Posted August 17, 2020 I get a popup message when I connect "An invalid character was found in text content" Line 0 What does this mean? I am also trying to enable Logging using a toggle switch though DI#3. I have been able to get one data log using the toggle but have not been able to get another. If I toggle On for 20 seconds then Off for 5 seconds then back On for another 20 seconds I would think I would get two logs? Does log 1 need to be closed somehow? Any help here would be appreciated. Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 18, 2020 Report Share Posted August 18, 2020 For the invalid character, it is not one I have seen before, but a quick search on the forum found this old post suggesting it can be caused by one of the XML files. So try this: For the logging activation, you should get a new file each time the switch is activated. From memory there was a minimum length requirement - something like if the log was shorter than 3 seconds it would not be saved. Is your DI3 set up as a GP input and switch type set to toggle? Make sure you are on the latest firmware (4.10.2) and put the runtimes "DI 3 GP Input Status", "Logging Status" and "Capacity" on a gauge on your screen may help you see what is going on. Quote Link to comment Share on other sites More sharing options...
Cemicks Posted August 18, 2020 Author Report Share Posted August 18, 2020 I found I had a bad ground. It is now working I updated firmware to 4:10:2. I’m looking at runtime values for Logging Status and Capacity. When I set up GP Input as a Switch Type Toggle with On Level Low it will start logging when I remove the 12v going to DI3 and Logging Status will flash green like it is trying to when I add the 12v. But it will not initiate logging if I have on level set to High. It just flashes like it is trying to. Capacity increases from 0% as it logs. if I set Switch Type to Momentary it will start logging if I flip power on then off in this condition I will not know if it is on or off as the momentary can occur on to off or off to on. should I try setting up with DI4 instead of 3? Im guessing it is the Active Edge associated with DI1-DI6 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.