Bethanyc Posted September 3, 2020 Report Share Posted September 3, 2020 Hay Link team i am going through the setup for knock setup so i can get some data, but i suspect my factory knock sensor is dead as its plugged in and is connected to the correct pin although i am not getting any signal at all in any of the runtime values when free revving, which leads me to suspect the sensor. If i can get the setup checked just in case i have missed anything. Thanks. Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 3, 2020 Report Share Posted September 3, 2020 A common trap, set the disable digital input to off and you will be away. Quote Link to comment Share on other sites More sharing options...
Bethanyc Posted September 3, 2020 Author Report Share Posted September 3, 2020 thanks Adam, blonde moment... i read the logic the other way around Quote Link to comment Share on other sites More sharing options...
Bethanyc Posted September 7, 2020 Author Report Share Posted September 7, 2020 thanks Adam that did it, i clearly didn't need that much gain as well a setting of 1 looked to be ok, Ill do an event to collect some data to see if needs to be on at all, but probably wouldn't hurt to set some high numbers to protect if a get a bad batch of fuel or something else playing up. thanks Again Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.