cruz177 Posted October 19, 2020 Report Share Posted October 19, 2020 good morning I would like to know if anyone knows how to adjust a 10 bar vdo oil pressure sensor. I have read that you would have to use a pullup resistor of about 200ohm. this is correct? how would the calibration be? thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted October 20, 2020 Report Share Posted October 20, 2020 Yes 200ohm 5V pull-up would be suitable. Setup cal table like below: cruz177 1 Quote Link to comment Share on other sites More sharing options...
cruz177 Posted October 20, 2020 Author Report Share Posted October 20, 2020 thanks a lot! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.