chickeneatman Posted October 20, 2020 Report Share Posted October 20, 2020 I have the dash wired to DI 9 and 10, Can setup doesn't seem to recognize it. Help files haven't been too helpful in this case either. It powers on correctly. Is there a configuration I am missing? blur2 - 20201018.pclx Quote Link to comment Share on other sites More sharing options...
Vaughan Posted October 20, 2020 Report Share Posted October 20, 2020 you've selected transmit user stream 1 but not setup anything in stream 1. Usually (depending on the dash) you would select Transmit Generic Dash or one of the other built in dash transmit options. What Dash do you have? I read your title, @Adamw might correct me on this but I believe you want to select "Transmit AIM MXS Strada Dash" Quote Link to comment Share on other sites More sharing options...
Adamw Posted October 20, 2020 Report Share Posted October 20, 2020 Yes, it should be just as Vaughan says. Your CAN 2 setup should look like below: chickeneatman 1 Quote Link to comment Share on other sites More sharing options...
chickeneatman Posted October 20, 2020 Author Report Share Posted October 20, 2020 Thanks again guys. I will give it a go this evening. Quote Link to comment Share on other sites More sharing options...
chickeneatman Posted October 21, 2020 Author Report Share Posted October 21, 2020 Gave it a try, and it worked. I actually at one point had it setup correctly other than the transmit frequency I had at 1hz vs the required 20 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.