Knock controle link g4+

[Rensjes12]

So i was making a log and my eye fell on this.

i setup the knock controle system, to retard a max of 2 degrees, it detected the knock, log sow -2 knk ign trim

But the ign angle is still the same as the table. does it indeed subtract 2 degrees ? but its not on the ign angle in the log?

see this picture to make it clear.

[Vaughan]

The knock retard is visible in the Cylx Knk I-Trim runtimes, the reason it doesn't show up in the main ignition angle value is that the retard numbers are typically cylinder based rather than overall.

[Rensjes12]

50 minutes ago, Vaughan said:

The knock retard is visible in the Cylx Knk I-Trim runtimes, the reason it doesn't show up in the main ignition angle value is that the retard numbers are typically cylinder based rather than overall.

oke thanks, 

my guesses are right then