pitz Posted November 10, 2020 Report Share Posted November 10, 2020 hello need help....my car is a bmw e46 engine 2jz vvti using ecu link fury. im confused about canbus and im using AEM cd7 dashe46 2jz vvti.pclr...it seems to only have display for rpm signal and battery voltage, occasionally ignition timing and water temp. However,this is not permanent as at times the display do not appear. First, I would like to have all the display to be shown in the meter. How can I achieve that? The base map is already attached. Thank you in advance! Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 10, 2020 Report Share Posted November 10, 2020 Change bit rate to 1MBit. Set OBD to off. Change channel 2 mode to off. Quote Link to comment Share on other sites More sharing options...
pitz Posted November 10, 2020 Author Report Share Posted November 10, 2020 ok i will try it thanx adam.. Quote Link to comment Share on other sites More sharing options...
pitz Posted November 10, 2020 Author Report Share Posted November 10, 2020 its still not work adam Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 10, 2020 Report Share Posted November 10, 2020 Please attach your dash config and ecu map again. Quote Link to comment Share on other sites More sharing options...
pitz Posted November 11, 2020 Author Report Share Posted November 11, 2020 e46 2jz vvti.pclr Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 11, 2020 Report Share Posted November 11, 2020 Did you attach the correct file? It has all the same mistakes in it and none of the changes I suggested. Quote Link to comment Share on other sites More sharing options...
pitz Posted November 12, 2020 Author Report Share Posted November 12, 2020 hello again adam....the dash everything functioning well...just left the gear level display and speed kilometre the dash not working..... i hereby attached my map for you as below https://drive.google.com/file/d/1yTCTUnUxXUDH3vxjdsVPbManl6XSqMma/view?usp=sharing Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 12, 2020 Report Share Posted November 12, 2020 For speed you will need to set your DI4 to one of the wheel speeds. GP Speed isnt transmitted to the dash. For gear position you will need to assign driven wheel speed in the >chassis and Body>speed sources menu to whatever wheel you set for DI4, then in >chassis and Body>Gear detection you will need to set it to RPM/Speed and then perform the gear calibration. Instructions are in the help file. Quote Link to comment Share on other sites More sharing options...
pitz Posted November 13, 2020 Author Report Share Posted November 13, 2020 DI3 also can??and how to transmitted speed to dash?? Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 13, 2020 Report Share Posted November 13, 2020 Just set DI4 to a wheel speed like I said. Quote Link to comment Share on other sites More sharing options...
pitz Posted November 16, 2020 Author Report Share Posted November 16, 2020 ok Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.