[email protected] Posted November 26, 2020 Report Share Posted November 26, 2020 Hi all. I am looking at purchasing this Aem guage for $100 and I have a question. If I purchase a Link Canbus 02 and connect it to my Link G4+ Storm Blue will it be compatible as a guage to display the air fuel ratio on the cars dash? Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 26, 2020 Report Share Posted November 26, 2020 No that is a wideband controller, not just a dumb display gauge. Quote Link to comment Share on other sites More sharing options...
[email protected] Posted November 26, 2020 Author Report Share Posted November 26, 2020 Adam could I buy this and do the same job and not spend 550.00 on the link canbus o2. Does it just connect to a bosch 4.9. Can I then feed an analog signal into the g4+storm blue? Or is this a bad road and should I just go the canbus way. What dumb guage connects to the canbus o2? Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 26, 2020 Report Share Posted November 26, 2020 By the look of the connector that is one of the older LSU4.2 AEM's. The analog output on them wasnt particularly accurate. The 4.2 sensors with the square plug are also hard to find in NZ. If you want a lambda controller with a gauge then I would probably suggest one of the newer AEM xseries gauges. These look similar to above but connect to the ecu with CAN. If you wanted a display for the Link CAN lambda then the cheapest option would be an old android phone with realdash or an OBD2 app on it. But you need to turn t on etc everytime you want to drive... Quote Link to comment Share on other sites More sharing options...
[email protected] Posted November 26, 2020 Author Report Share Posted November 26, 2020 Thanks heaps. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.