Boost Map configuration problem & Dash Link Speed signal problem

[Bud]

Hi All,

I have problem on my Link ECu Plug IN G4x Subaru WRX9

i try to setup 3 boost map by switch. i join pictures from setup

i think setting is correct but when i activate switch, on software activate wastegate table 2 or 3 correectly> but in reality when you test on driving all stay to 0. Also strange the green cursor no jump on different table.

i try to join movie

2nd problem, on this car we connect Link Dash strada MXS 1.2

i have no speed signal on dashboard by the CAN.

Speed working on link software but nothing on dashboard

i test all signal (speed 1, speed2 etc>>) it is same>

 

thanks in advance

https://drive.google.com/file/d/1afBhv9IeL58yDtu3LxU1gat54D9UIne5/view?usp=sharing

 

[Vaughan]

[Bud]

24 minutes ago, Vaughan said:

 

https://drive.google.com/file/d/1afBhv9IeL58yDtu3LxU1gat54D9UIne5/view?usp=sharing

[Vaughan]

attach a copy of your tune please and a log of you turning the switch on and off

[Bud]

3 minutes ago, Vaughan said:

attach a copy of your tune please and a log of you turning the switch on and off

i have just base map no log

but i can do some log

Subaru WRX V9 G4X Xtreme Plugin FlexFuel 4b 1700cc 01.pclx

[Vaughan]

for your 2nd problem I think the Dash stream uses the individual wheel speeds so setting one of the wheel speed sources to DI 5 should make it show up in the dash

[Bud]

21 minutes ago, Vaughan said:

for your 2nd problem I think the Dash stream uses the individual wheel speeds so setting one of the wheel speed sources to DI 5 should make it show up in the dash

thanks i will test on dyno tomorrow

[koracing]

Have you tested the boost control duty cycles in table 1 to ensure the values you are entering in tables 1, 2, and 3 are effective for the boost level you are trying to achieve?  What solenoid are you using with your PWM frequency of 15Hz? How is your switch set up for activating tables 2 and 3?